Home > LED Controller & Dimmer > LED RGB Controller w/ Sync-able RF Touch Color Remote

LED RGB Controller w/ Sync-able RF Touch Color Remote

Part Number : LRF-RGBx6

Choose your LED Product and BUY!

* Required Fields

RRP $39.95

$39.95

(Price ex. VAT)

Qty:

Stock Status: In Stock

Buy in Bulk and Save:

Qty Discounts Off Price
1-4 $39.95	5-9 $35.96	10-14 $33.96	15+ $31.96

Email US NOW & PLACE YOUR ORDER: Sales@LEDStripRoom.com

Next Day Delivery - FREE on orders over $199

Cut off time 4pm / 48hr Delivery also available

hours
mins
secs

Time left to qualify for Next Day Delivery

LED RGB Controller w/ Sync-able RF Touch Color Remote

More Views

Product Description

Universal Red/Green/Blue (RGB) LED Controller & Dimmer with handheld RF Touch Color Remote can control any 12VDC RGB LED products. Unique synchronization function constricts remote to one controller, or to multiple controllers for use with one remote. Select from several static single color modes or 15 dynamic color-changing modes with speed, dimming, ON/OFF controls. Maximum load is 6 amps per channel, 18 amps total.

Product Specifications:

Applications: Direct access color selection and functions with dimmable and speed controls

Function: Control 3 channel RGB LED products using wireless RF remote

Operating Voltage: 12 VDC – match power supply voltage to RGB LED product voltage

Connection Mode: Common Anode (+)

Dimensions: 0.225cm(0.09") x 0.25cm(0.1") x 0.094cm(0.04")

Output: Three CMOS drain-open output

Maximum Load Current: 12VDC – 6 Amps per channel (18 Amps total) / 24VDC - 6 Amps per channel (18 Amps total)

Output Power: 216 Watts

Control Method: Wireless RF Remote Control - Frequency 433MHz

Batteries Required: Three AAA batteries

Modes: 39 Total (24 static single color and 15 dynamic color changing)

Operating Tempurature: -25~60°C

Standards and Certifications:

Typical Applications:

Multi-Receiver Programming:

The LRF-RGBx6 features transmitter to receiver keying to help eliminate interference from other nearby units. If you wish to control several receivers from a single transmitter, the receivers first must be re-programmed. The easiest and fastest way to re-program several receivers at once is to have them share a power supply or all plug in to a single power strip (Once programmed you can provide power as you would otherwise, sharing is only needed for the programming phase to ease the process -- Re-programming can be done one device at a time also).

Programming Procedure:

1. Wire all receivers to one power supply or power strip but don't turn it on yet.

2. With the power off, grab the remote.

3. Turn on the power supply.

4. Within 3 seconds of providing power press the

button once.

If programming was successful any connected light strings should blink three times.

Note：

Do not scratch the sensing area. Do not disassemble, repair, or modify the device.

Disconnect the power (adapter) before installing/removing this controller.

Do not use this device near water, or moisture for indoor use only.

This product should only be operated from the type of power source indicated on the label.

When multiple receivers share one remote, it's possible for the patterns to visually drift apart over time. The single color modes are unaffected and remain synced.